Retrofit drawer in rear shelf - AZ68.30-P-0002-02P

Model 203.0 up to chassis no. A054321 and F036591 

REAR SHELF

1. Screw four mounts (1) with one screw each (2) to rear shelf.

   Start screws (2) in front holes toward front of vehicle. Align free nuts mounts to rear hole when tightening.

   Fig 1: Identifying Mounts, Screws And Rear Shelf

   
2. Position right guide rail (4) on rear shelf and screw to free mount nut (1) with two screws (5) and spacer sleeves (3).

   Position guide rail to rear shelf so that drawer guide points toward center of vehicle (arrow).

3. Install left guide rail in same manner.
   Fig 2: Identifying Guide Rail, Mount Nut, Screws And Rear Shelf

   
4. Press catch of left and right drawer lock (6) against spring force toward inside, position drawer in guide rails (4) and slide in to front end stop.

   When inserting the drawer locks catch noticeably into the rear end stops (7) after approx. 100 mm. Only a slightly increase in the force is required to overcome the stops. If the drawer cannot be inserted into the guide rails or only with increased force loosen one or both guide rails and adjust easy motion for guides by moving rails to side.

   Fig 3: Identifying Right Guide Rail, Rear Shelf And Spacer Sleeves

   
5. Check easy motion of drawer, adjust if necessary.
   • When pulling the drawer in or out from the end position a slight resistance should be felt when the drawer locks are released from the end stops.
   • When the drawer locks are released it should be possible to move the drawer easily and the drawer should arrest when the end stop is reached.
   • For adjusting easy motion and catch resistance loosen one or both guide rails and move toward inside or outside.