Installing instrument - AZ54.65-P-0001-05M

Model 203.0 

1. Connect connector for rear interior lamp (E15/3) to rear PTS warning display (A44/3) (see arrow).
2. Connect warning display wiring harness (1b) to 6-pin connector for rear PTS warning display (A44/3) and route to left C-pillar along present wiring harness.

   This wiring is obligatory for reasons of electro-magnetic compatibility (EMC).

   Fig 1: Identifying Rear Interior Lamp, PTS Warning Display And Wiring Harness

   
3. Route warning display wiring harness (1b) to rear wheelhouse through cable passage in trunk along present leads and fasten (see dotted line).

   Carefully fasten warning display wiring harness (1b) to present leads in the area of the windowbags. 

4. In the area of the bottom C-pillar fasten warning display wiring harness (1b) to standard wiring harness located closer to the left rear door (see arrows).

   This wiring is obligatory for reasons of electro-magnetic compatibility (EMC).

   Fig 2: Identifying Warning Display Wiring Harness