Steering noises when driving curves - AF46.25-P-1701CG

MODELS 203.035 /045 /235 /245 /735 /745 /747

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Category	Op. no.	Operation text	Time	Acc. no.	Code
P	023622	Work: Checking position of filter element in oil reservoir for power steering pump	005 work units/0.4 h.	-	-

Damage code	Cause	Remedy
	Due to unfavorable tolerances between filter element and oil reservoir, air can be sucked in when cornering during the warm-up phase. The resulting noises when the steering system is moved sound like when the steering system is being bled) (rumbling/humming)	1 Remove engine cover. White filter element can be moved approx. 1 - 2 mm in oil reservoir and clacks which is normal
	The noise is disappears as the steering oil temperature increases.	2 Move filter element toward rear (away from front of vehicle) to stop (figures).
		3 Fill steering oil to maximum level.
		4 Install engine cover.

Fig 1: Identifying Filter Element (1 Of 2)

G04737098

Arrow Pressure direction

Fig 2: Identifying Filter Element (2 Of 2)

G04737099

PARTS ORDERING NOTES

Part no.	Designation	Quantity
001 989 24 03 10	Power steering oil (Pentosin)	as required