Retrofitting CD changer in stowage compartment - AN82.64-P-0001-02PA

Models 203.0, 203.2, 203.7 

1. Remove the three transport securing devices on the underside of the CD player with changer (in the glove compartment) (A2/6) as per the instructions.
2. Seal the openings in the transport securing devices with the stickers enclosed (see enlarged section).
   Fig 1: Identifying CD Player With Changer - Models 203.0, 203.2, 203.7

   
3. Pull the protective cap off the connection for the fiber optical cable (see arrow) on the back of the CD player with changer (in the glove compartment) (A2/6)
   Fig 2: Locating CD Player With Changer And Fiber Optical Cable

   
4. Slide the CD player with changer (in the glove compartment) (A2/6) into the bracket (5) (see arrow) and tighten securely with four M4 _6 screws (6).
   Fig 3: Identifying CD Player With Changer Bracket And Screws

   
5. Contact the wiring harness for the fiber optical cable (1) and the wiring harness for the CD changer (2) to the CD player with changer (in the glove compartment) (A2/6) as per the figure.
6. Clip the wiring harness for the fiber optical cable (1) into the guides provided (see arrows).
   Fig 4: Identifying CD Player With Changer, Guide And Fiber Optical Cable

   
7. Slide the CD player with changer (in the glove compartment) (A2/6) with the fixing lug on the left side (see arrow) into the existing fixing hole in the glove compartment.
   Fig 5: Identifying CD Player With Changer And Fixing Lug

   
8. Screw on the CD player with changer (in the glove compartment) (A2/6) using a 5x16 sheet metal screw (see arrow).
   Fig 6: Identifying CD Player With Changer And Sheet Metal Screw