Retrofit portable CTEL holder of hands-free system - AZ82.70-P-0005-01PP

When installed on telephone console 

1. Align base holder (2) on console (12) as shown in illustration, mark holes and drill with 3 mm dia. bit.
2. Screw base holder (2) onto console (12) with the 3 screws (3) included.
   Fig 1: Identifying Base Holder On Console

   
3. Insert portable cellular telephone holder (1) into base holder (2).
4. Hook connection lead below console (12) with coil of spiral lead as shown in figure (arrow) and arrest from inside with adhesive felt.
   Fig 2: Identifying Portable Cellular Telephone Holder And Base Holder

   
5. Route connector (8) into radio shaft.
   Fig 3: Identifying Connector Routed Into Radio Shaft