Turn signal lamp malfunction in headlamp housing - AF82.10-P-2014A

MODEL WDB203.### #A up to 339771, WDB203.### #F up to 261050, ADB203.### #R up to 053444

Operation no. of operation texts or standard texts and flat rates

TURN SIGNAL LAMP MALFUNCTION

Category	Op. no.	Operation text
P	547947	Replace turn signal lamp socket in headlamp housing

TURN SIGNAL LAMP MALFUNCTION

Damage code	Cause	Operation text
82 104 74	Contact problems between turn signal lamp socket and headlamp housing.	Replacement of the complete headlamp assembly will not be recognized for warranty or goodwill!
	Contact between turn signal lamp socket and headlamp overheated and burned due to low contact pressure and high transition resistance.	Install turn signal lamp socket including wiring harness only in the case of complaint Perform repair only on the affected vehicle side
		1 Remove turn signal lamp socket (E1e2, E2e2) from headlamp housing. 2 Check outer contacts of lamp socket for damage (contact burn). In the event of visible damage proceed with step 3.	AR82.10-P-1201P
		3 Disconnect electrical connector from headlamp housing.
		4 Unpin actuation line (1) for turn signal lamp from connector (2). Open lock (3) to prevent contacts from being destroyed. Left turn signal lamp: pin 1 (black/white-sw/ws) Right turn signal lamp: Pin 1 (black/green-sw/gn)
		↓
		5 Remove contacts from sensor's laminated contact connector.	AR00.19-P-0120-02B
		6 Plug empty chamber with blind plug.
		7 Insert actuation line (1) for turn signal lamp in connector housing (4) (pin 1) of repair set. Before installing single-conductor seal check for damage.
		8 Connect plug housing (4) with connector (5) of repair wiring harness. Housing should catch audibly.
		9 Screw terminal (6) of repair wiring harness to ground (ground output - component compartment - right) (W16/4) or ground (ground output - component compartment - left) (W16/3).
		10 Install turn signal lamp socket (E1e2, E2e2) in headlamp housing.
		11 Connect electrical connector (2) to headlamp housing.
		12 Fasten repair wiring harness with two tie straps along original wiring harness. Select mount so that noise is prevented.
		Parts will be available in the middle of 05/2002. in GLC Germersheim

Fig 1: Identifying Power Ground Compartment Assembly

Fig 2: Identifying Vehicle Side Wiring Harness

Fig 3: Identifying Repair Wiring Harness

Fig 4: Identifying Wiring Harness Repair Kit (220 589 01 99 00)

Fig 5: Identifying Blade Holder With Clamping Pliers (220 589 01 99 50)

Fig 6: Identifying SLK 2.8 Blade (220 589 01 99 62)

Parts ordering notes

PARTS ORDERING NOTES

Part no.	Designation	Quantity
203 826 01 82	Repair set, ECE version (black turn signal lamp socket), one side of vehicle	1
203 826 02 82	Repair set, USA version (white turn signal lamp socket), one side of vehicle	1