Pulling tapered roller bearing inner race off drive pinion - AR35.31-P-0550-10C

Fig 1: Identifying Puller (001 589 50 33 00)

Fig 2: Identifying Extension (000 589 63 34 00)

Fig 3: Identifying Collet Chuck (000 589 34 34 00)

Fig 4: Identifying Open-End Wrench (140 589 00 01 00)

Put together puller (024)with extension (024c) and clamping pliers (024a) and tighten.
Use open wrench if necessary for assembling or dismantling the extension (024c) .

Fig 5: Identifying Clamping Pliers, Extension And Puller
Push puller (024) with clamping pliers (024a)over the tapered roller bearing inner race and clamp securely behind the rollers (arrow) using a roll pin (024b).
Using puller (024), detach tapered roller bearing inner race from drive pinion (47) and remove

Fig 6: Removing Tapered Roller Bearing Inner Race From Drive Pinion