Pulling tapered roller bearing inner race off drive pinion - AR35.31-P-0550-10A

Fig 1: Identifying Puller (001 589 50 33 00)

Fig 2: Identifying Extension (000 589 63 34 00)

Fig 3: Identifying Collet Chuck (000 589 02 34 00)

Fig 4: Identifying Open-End Wrench (140 589 00 01 00)

Assemble puller (024) with extension (024c) and clamping pliers (024a) and tighten.
Use an open wrench if necessary to assemble and disassemble the extension (024c).

Fig 5: Identifying Clamping Pliers, Extension And Puller
Push puller (024) with clamping pliers (024a) above the tapered roller bearing inner race and clamp securely behind the rollers (arrow) using a roll pin (024b).
Using the puller (024), detach the tapered roller bearing inner race from the drive pinion (47) and remove.

Fig 6: Removing Tapered Roller Bearing Inner Race From Drive Pinion