Engine cannot be shut off, selector lever locks in "P" - AF27.60-P-6401A

TRANSMISSION 722.6 in MODEL 215, 220, 230 with CODE (889) Keyless go 

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Range	Op. no.	Operation text	Time	Acc. no.	Code
P	541011	Perform quick test	004 WU/0.3h	-	-
P	272355	Remove/install electronic selector lever module, replace according to condition, for model 230	023 WU/1.9 h	-	-
P	272355	Remove/install electronic selector lever module, replace according to condition, for models 215/220	018 WU/1.5 h	-	-

Damage code	Cause	Remedy
	Communication interferences following internal reset of electronic selector lever module	1 Remove/install/replace floor shift.
	Following electronic selector module reset, the electronic selector lever module goes to the intermediate position "P-R" (actual values).	Observe vehicle model and national version.
	Engine cannot be shut off with button on selector lever module, if started previously with keyless go.	SBC added value can be recognized on the presence of the features "SBC hold" and "SBC stop".
	Position "R" can be displayed in instrument cluster (position "P" is not recognized).	Immediate measure (until replacement part is present in workshop): ↓ 2 Inform customer, that vehicle can only be started with key in electronic ignition/starter control module (EIS).

PARTS ORDERING NOTES

Part no.	Designation	Quantity
A 220 267 33 24	Selector lever module, only for models 215/220 (ECE + USA/Canada/Australia)	1
A 230 267 46 24	Selector lever module, only for model 230 (ECE without SBC added value, not for USA/Canada/Australia)	1
A 230 267 49 24	Selector lever module, only for model 230 (USA/Canada and Australia with SBC added value)	1
A 230 267 52 24	Selector lever module, only for model 230 (Australia with SBC added value, not for USA/Canada/ECE)	1
A 230 267 55 24	Selector lever module, only for model 230 (ECE with SBC added value, not for USA/Canada/Australia)	1