Retrofitting fire extinguisher - AN86.10-P-0001N

MODEL 215 

Fig 1: Identifying Fire Extinguisher Components

	Removing
1	Move driver seat fully back and raise
2	Open flap (1) and lift out storage compartment (2) together with assembly wedge (3) on left and right	Part is not required.
			Fig 2
3	Detach flap (1) from storage compartment on right and left (see arrows)
		Part is replaced.
	Installing
4	Place tensioning strap (4) around seat frame (6) and attach with tabs (5) in tensioned state
5	Install new flap (8) and connect tensioning strap (4) to each other by pin (7)	Tensioning strap (4) must be guided through flap (8) (see illustration).
6	Insert fire extinguisher (9) and close flap (8)
N	In the event of modification to equipment fitted, subsequently enter code or designation of relevant special equipment on vehicle datacard / FDOK

Fig 2: Identifying Assembly Wedge (110 589 03 59 00)

PARTS ORDERING NOTES

Part no.	Designation	Quantity
KG 86	Fire extinguisher	1
KG 91	Tensioning strap	1
KG 91	Spacer	1
KG 91	Cover	1