Remove/install door sealing frame - AR72.10-P-2120M

MODEL 220 

Fig 1: Identifying Door Sealing Frame Remove/Install Components

	Remove/Install
		Always replace door sealing frame after installation.
1	Remove old door sealing frame (2)	Do not use any sharp-pointed tools in order to avoid damaging paintwork
2	Remove glue residues from door frame (1) and degrease subsurface with naphtha
3	Remove protective strip (3) from gluing surface on new door sealing frame (2) starting with shaped bow.
4	Position new door sealing frame (2) with shaped bow first on upper corner of door (arrow A) and press down lightly	Ensure that door sealing frame (2) is seated properly.
5	Remove protective strip (3) continuously from gluing surface and completely position door sealing frame (2)	Pay attention to slight bow (arrow B) on door hinge Do not stretch door sealing frame (2)
6	Uniformly press on door sealing frame (2) with hand roller (4)	Hand roller	Figure

Fig 2: Identifying Roller (168 589 05 63 00)