Removing and installing inclination sensor (anti-towing sensor) - AR80.50-P-0001M
MODEL 215, 220 with CODE (551a) Anti-theft alarm (ATA)
Illustrated on model 220
Fig 1: Identifying Inclination Sensor (Anti-Towing Sensor) Remove/Install Components - Illustrated On Model 220
| Removal, installation | |||
| 1.1 | Remove front seat cushion | Model 220 | AR91.12-P-1020MA |
| 1.2 | Remove individual seats | Model 220 with code 401, only right side | AR91.12-P-1020M |
| Model 215, only right side | AR91.12-P-1020N | ||
| 2.1 | Remove seat adjustment device on rear seat | Model 220 with code 401, only right side | AR91.12-P-1520M |
| 3 | Unscrew nuts (1), unscrew screws (2) and remove mounting plate (3) from vehicle floor | ||
| 4 | Disconnect connector from ATA inclination sensor (B33) | ||
| 5 | Remove mounting plate (3) from vehicle floor and turn | ||
| 6 | Bend tongue (5a) on bracket (5) in direction of arrow | ||
| 7 | Remove ATA inclination sensor (B33) from mount (5) toward center of vehicle | ||
| 8 | Install in opposite order |