  |
Remove/Install |
|
|
 |
Risk of poisoning
caused by swallowing brake fluid. Risk of injury caused by brake fluid coming into contact with skin and eyes. |
Pour brake fluid only into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. |
AS42.50-Z-0001-01A |
 |
Notes on handling brake fluid |
|
AH42.50-P-0001-01A |
|
Notes on repairs to brake system |
|
AH42.00-P-0003-01A |
|
Notes on externally invisible brake fluid loss |
|
AH42.10-P-9406-02A |
|
In order to prevent paint damage, brake fluid which has escaped must be rinsed off immediately with water |
|
|
| 1 |
Open engine hood |
|
AR88.40-P-1000M |
| 2 |
Suction off brake fluid from the reservoir (10) |
|
|
| 3 |
Detach plug (10b) |
|
|
| 4 |
Unscrew bolt (10a) |
|
|
| 5 |
Remove reservoir (10) from master brake cylinder (1) |
Replace gaskets (9). |
|
| |
Detach brake lines (5) from master brake cylinder (1) and seal connections with plugs |
Box wrench bit |
Fig 2 |
| |
|
Box wrench bit |
Fig 3 |
| |
|
Set of plugs |
Figure |
| |
|
 |
*BA42.10-P-1003-04A |
| 7 |
Detach pendulum support (113) from master brake cylinder (1) |
|
AR42.10-P-0300-02N |
| |
|
|
*BA42.10-P-1003-05A |
| 8 |
Unscrew hexagon nuts (19, 2 pieces) |
|
*BA42.10-P-1001-05A |
| 9 |
Remove master brake cylinder (1). |
Do not tilt master brake cylinder but pull out straight forwards otherwise the thrust rod is pressed out off its axial position.
Installation: Replace sealing ring (1a). |
|
| 10 |
Install in the reverse order |
|
|
| 11 |
Bleed brake system |
|
AR42.10-P-0010I |
 |
Check |
|
|
| 12 |
Check brake system for leaks |
|
AR42.10-P-0100-01A |