Remove/install rear door window - AR72.12-P-1920MB

MODEL 220.1 /8 with CODE (Z07) Top protection 

Fig 1: Identifying Rear Door Window Remove/Install Components

	Remove/install
	Risk of injury caused by hands or feet being jammed or crushed when working on windshield or windows	Secure windows against dropping, use only specified lifting tools, wear protective shoes.	AS67.00-Z-0003-01A
	Notes on avoiding damage to windows installed in special high-security vehicles		AH67.00-P-0003-01FB
1	Close window (3) and secure with clamping pliers	Cover door frame in area of clamping pliers with suitable equipment to avoid damaging paint.
			Figure
2	Remove door lining from rear door		AR72.12-P-1010MB
3	Remove rear door inner door panel		AR72.12-P-0104MB
4	Remove window lifter from rear door		AR72.12-P-1810MB
5	Remove rear door handle armor plate		AR72.12-P-2410-01MB
			*BA72.12-P-1002-01DA
			*BA72.12-P-1007-01DA
6	Remove lower window guide rail (2)	Do not yet remove upper window guide rail (1).	AR72.12-P-1500MB
7	Install wooden block (4) for supporting window (3) in rear door
	Hard wood for supporting rear door window		WF58.50-P-7212-01MB
8	Carefully lower window (3), set down on wooden block (4) and secure against falling out
9	Remove upper window guide rail (1)		AR72.12-P-1500MB
10	Remove window (3)	Remove window (3) with aid of helper
11	Install in the reverse order

REAR DOOR TIGHTENING TORQUE

Number	Designation		Model 220 with code Z07
BA72.12-P-1002-01DA	Bolt, door handle armor plate to door	Nm	28
BA72.12-P-1007-01DA	Bolt, window guide rail at angle	Nm	9

Fig 2: Identifying Clamping Pliers (220 589 04 31 00)