Removing and installing window lift mechanism in front door - AR72.10-P-1800N

MODEL 215 

Fig 1: Identifying Window Lift Mechanism In Front Door Remove/Install Components

	Removal, installation
1	Remove door paneling in front door		AR72.10-P-1000N
2	Disconnect left/right door loudspeaker connector (X1/6; X1/7)
3	Unscrew screws (10) and remove woofer speakers (H4/1h2; H4/2h2)		Figure
4	Pull off insulating mat in area of inner door panel
5	Remove crank window from front door		AR72.10-P-1900N
6	Remove front left/right power window motors (M10/3; M10/4)		AR72.29-P-1860N
7	Unscrew nut (6) and unhook power window (1) from inner door panel (2)		*BA72.10-P-1009-01E
8	Remove caps (4) on nuts (3) on bottom door panel (5) and unscrews nuts (3)		*BA72.10-P-1009-01E
		Installation:  Adjust crank window on front door	AR72.10-P-1950N
9	Loosen nut (8) and unhook power window (1) from mount (9)		*BA72.10-P-1009-01E
		Installation:  Adjust crank window on front door	AR72.10-P-1950N
10	Press mounting sleeves (7) through inner door panel
11	Lift power window (1) until stud bolts (1a) on bottom door panel (5) are unhooked and remove power window (1) through installation opening in inner door panel (2)
12	Install in opposite order

FRONT DOOR TIGHTENING TORQUE

Number	Designation		Model 215
BA72.10-P-1009-01E	Screw for power window on front door on inner door panel	Nm	9

Fig 2: Identifying Torx Bit Set (000 589 01 10 00)