Remove, install window in front door - AR72.10-P-1910MC

MODELS 220.175 /178 with CODE (Z04) Light armoring 

Fig 1: Identifying Window In Front Door Remove/Install Components

	Remove/install
	Operations involving work on glass panes and windows are potentially dangerous; use caution to avoid allowing hands or feet to become caught.	Secure windshield and windows from dropping down; use only the lifting tools specified for such operations. Wear safety shoes.	AS67.00-Z-0003-01A
	Instructions for avoiding damage to windows installed in special high-security vehicles	MODEL 210 with Code Z04, Code Z06 MODEL 220 with Code Z04, Code Z07	AH67.00-P-0003-01FB
1	Remove door liner from front door		AR72.10-P-1000MC
2	Remove front door foil		AR72.10-P-1010MC
3	Remove outer sealing rail		AR72.10-P-1700E
4	Remove inner sealing rail (5)
5	Remove front door side airbag unit		AR91.60-P-0690MC
6	Detach armor plate (2) at window (1)	Lower power window
			*BA72.10-P-1007-01EA
7	Position window (1) so that the bolts (4) are accessible	Connect door control module
8	Secure window using clamping pliers	Use protective foil
		Tensioning clamp	Figure
9	Unscrew screws (4)
10	Lower power window to approx. 5 mm before the limit stop
11	Detach clamping pliers from window, remove window	Move front window down, then up, remove from outside.
12	Install in the reverse order

FRONT DOOR TIGHTENING TORQUE

Number	Designation		MODEL 220 with CODE Z04
BA72.10-P-1007-01EA	Bolt for armor plate to power window	Nm	23

Fig 2: Identifying Clamping Pliers (220 589 04 31 00)