Removing and installing SAM control module with fuse and relay box, front right - AR54.21-P-1261I

MODEL 215, 220 

Fig 1: Identifying Sam Control Module Remove/Install Components (Front Right) - Shown On Model 220

Shown on model 220 

	Removing, installing
1	Connect quiescent retention device		AR54.10-P-1030-07I
2	Disconnect ground cable from battery		AR54.10-P-0003I
3	Open engine hood and position upright		AR88.40-P-1000M
4	Unlock and remove cover on right fuse box (F1.1)
5	Fold up clamping lever (1) of supply (terminal 30) and remove cable
	Fuse assignment, build condition		GF54.15-P-1256I
	Relay assignment, build condition		GF54.15-P-1257I
6	Unclip fuse carrier (4) on control module unit (passenger-side SAM control module (N10/7) with right front fuse and relay module (K40/7)).	Once the retaining lugs (arrow) have been pressed in the direction of the arrow, the fuse carrier can be taken out from the top. The components fitted to the right front fuse and relay module may vary depending on the equipment.
7	Remove the remaining couplings on the front right fuse and relay module
8	Pull out control module unit from above	Only pull out until the couplings (3) on control module unit (right front fuse and relay module (K40/7) and passenger-side SAM control module (N10/6)) are accessible
9	Unlock and remove couplings (3)	If passenger-side SAM control module or right front fuse and relay module are defective: ↓
		Disconnect SAM control module from fuse and relay module	AR54.21-P-1259-01I
10	Install in reverse order