Retrofitting ski bag - AN91.22-P-0001N

MODEL 215 

The skibag can hold 2 pairs of skis.

When retrofitting, a fuel tank with  skibag recess must be installed in place of the standard 78-liter fuel tank.

Not applicable to models with refrigeration compartment in center rear armrest (code 308).

Fig 1: Identifying Bulkhead, Ski Bag Housing, Ski Bag, Ski Bag Mount And Bracket - Model 215

Fig 2: Identifying Ski Bag Housing, Ski Bag, Ski Bag Mount, Bracket, Material Cover And Rear Armrest - Model 215

	Risk of explosion  from ignition, risk of poisoning  from inhaling and swallowing fuel as well as risk of injury  from skin and eye contact with fuel.	No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel.	AS47.00-Z-0001-01A
	Notes on skibag		AH91.22-P-0001-01A
	Removal
1	Disconnect ground lead from battery	Except on models with refrigeration compartment in center rear armrest (code 308).
			AR54.10-P-0003I
2	Remove rear seat cushion
			AR91.12-P-1020N
3	Remove storage box rear seats
			AR91.12-P-1760M
4	Remove rear seat backrest
			AR91.12-P-1620MA
5	Remove cloth cover (17) at rear backrest (18)
6	Remove insulation mat in rear	Except on models with refrigeration compartment in center rear armrest (code 308).
N	Remove paneling in trunk	The rear wall trim and floor covering are not required; except on models with refrigeration compartment in center rear armrest (code 308).
			AR68.30-P-4600M
8	Remove fuel tank	Except on models with refrigeration compartment in center rear armrest (code 308).
			AR47.10-P-4100IA
	Installation
9	Install fuel tank	Except on models with refrigeration compartment in center rear armrest (code 308).
			AR47.10-P-4100I
10	Retrofit skibag housing	Except on models with refrigeration compartment in center rear armrest (code 308).	AN91.22-P-0001-03M
11	Install trim panels in trunk	Except on models with refrigeration compartment in center rear armrest (code 308). Floor covering is new part.
			AR68.30-P-4600M
12	Bolt on plate (16) for snap hook at crossmember below rear seat cushion
13	Fit remaining parts to vehicle
14.1	Remove refrigeration compartment from rear armrest and place in trunk (part remains with customer)	Only on models with refrigeration compartment in center rear armrest (code 308). See owner's manual
15	Insert skibag (11) into skibag mount (12) and close cover	The side with long prongs (see enlarged detail) is inserted into the skibag mount on the left and then clipped to the short prong on the right-hand side.
16	Fill fuel tank	Except on models with refrigeration compartment in center rear armrest (code 308).
			AR47.10-P-4001B
	Inspecting
17	Carry out version coding for fuel tank version	Except on models with refrigeration compartment in center rear armrest (code 308). See Star Diagnosis
18	Carry out operational check	See Operating Instructions
19	In the event of modification to equipment fitted, subsequently enter code or designation of relevant special equipment on vehicle datacard / FDOK