Retrofit interior blower wiring harness - AN83.10-P-0001N

MODEL 215 

The current brown fuse holder (35) is replaced by a max. fuse (see arrow).

Fig 1: Identifying Interior Blower Supply Line Wiring Harness And Right Fuse Box - Model 215

	Removal
1	Disconnect ground cable of battery	A quiescent current retention unit is not to be installed on vehicles fitted with Tele Aid (Code 347).
			AR54.10-P-0003I
2	Remove right front floor covering	Only remove as far as necessary until the foot rest is accessible.
			AR68.20-P-2070M
3	Remove right front foot support
4	Remove and install right front SAM control module with fuse and relay box.	Move to one side to expose the roof guide in the footwell.
			AR54.21-P-1261I
	Installation
5	Reroute interior blower wiring harness		AN83.10-P-0001-01MN
6	Install right front SAM control module with fuse and relay box
			AR54.21-P-1261I
7	Reconnect ground lead to battery
			AR54.10-P-0003I
	Check
8	Read fault memory and erase	Conduct brief test with Star Diagnosis.
9	Check operational capability of interior blower
10	Fit remaining parts to vehicle
11	Place insert sheet with new fuse assignment into Owner's Manual	Print out document.	AN83.10-P-0001-02MN