Remove/install fan shroud - AR20.40-P-6800IM

ENGINE 275.980 in MODEL 215.379, 220.179 

Shown on model 220 

Fig 1: Identifying Fan Shroud Remove/Install Components - Shown On Model 220

Shown on model 220 

Fig 2: Identifying Removal/Installation Coolant Line And Bolts - Shown On Model 220

Fig 3: Identifying ATF Line And Radiator Remove/Install Components

	Remove/install
1	Remove engine trim panel		AR01.10-P-2405IM
2	Remove left and right suction fan duct
3	Drain coolant at radiator (9)		AR20.00-P-1142H
	Notes on coolant	All engines	AH20.00-N-2080-01A
4	Unscrew bolts (6), coolant line (2) and coolant line (7) from coolant temperature control switch to radiator
5	Unscrew bolt from retaining tabs (3) on fan shroud (1)
6	Separate electric plug sockets at suction fan
7	Unscrew automatic oil line (8)	Before opening the automatic transmission or its components, the ambiance of the separation point has to be cleaned thoroughly. Even the smallest particles of dirt, introduced into the hydraulic components, can result in malfunctions and a total failure of the automatic transmission. Only remove at top right of radiator. Seal ATF lines so that no ATF flows out.
			*BA20.20-P-1001-01A
8	Remove fastening shackles for engine oil line below at fan shroud (1)
9	Remove mounting clamps for fan shroud (1) at radiator (9)
10	Remove fan shroud (1)	Pull fan shroud (1) with retaining lugs (4) out of retaining tabs at radiator (9).
11	Install in the reverse order
12	Adjust coolant to correct level		AR20.00-P-1142H
13	Bleed cooling system		AR20.00-P-1142-06GA
14	Inspecting cooling system for leaks		AR20.00-P-1010HA
15	Check oil level in automatic transmission, correct if necessary		AR27.00-P-0100AC

RADIATOR, COOLANT HOSES