Remove/install fan shroud - AR20.40-P-6800AC

ENGINE 137 in MODEL 215, 220 

ENGINE 275.950 in MODEL 215.376, 220.176 

ENGINE 275.951 in MODEL 230.476 

ENGINE 275.981 in MODEL 230.479 

ENGINE 275.954 in MODEL 230.477 

Shown on model 220 

Fig 1: Identifying Fan Shroud Remove/Install Components - Shown On Model 220

	Remove/install
1.1	Remove front part of engine cover	Model 215.376, 220.176, 230.476 /477	AR01.10-P-2405LA
		Model 215.379, 220.179, 230.479	AR01.10-P-2405IM
2	Remove left and right suction fan duct
3	Unscrew bolts from retaining tabs (3) on fan shroud (1)
4	Disconnect electric plug sockets at suction fan
5	Remove automatic oil line	Before opening the automatic transmission or its components, the ambiance of the separation point has to be cleaned thoroughly. Even the smallest particles of dirt, introduced into the hydraulic components, can result in malfunctions and a total failure of the automatic transmission. Only remove at top right of radiator. Seal ATF lines so that no ATF flows out.
			*BA20.20-P-1001-01A
6.1	Remove fastening shackles (3) for coolant line below at fan shroud (1)	Model 215, 220
7	Remove fan shroud (1)	Pull fan shroud (1) with retaining lugs (4) out of retaining tabs at radiator.
8	Install in the reverse order
9	Check oil level in automatic transmission, correct if necessary		AR27.00-P-0100AC

RADIATOR, COOLANT HOSES