Retrofit interior motion sensor - AN80.50-P-0100N

MODEL 215 up to 31.8.02 with code (551a) Anti-theft alarm system (ATA) 

Fig 1: Identifying Retrofit Interior Motion Sensor Components (1 Of 2) - Model 215

Fig 2: Identifying Retrofit Interior Motion Sensor Components (2 Of 2) - Model 215

	Remove/Install
1	Connect quiescent current retention device		*WH58.30-Z-1012-09A
2	Disconnect ground cable of battery
			AR54.10-P-0003I
3	Remove cover on center console
			AR68.20-P-2350N
		If recess clearance for TS/IRS switch (N72/1s7) is not present, send center console cover to manufacturer for cutting: ↓
		Request form for machining hole	OF68.00-P-3000-01A
4	Remove upper control panel control module
			AR54.21-P-1262N
5	Remove switch group (11) from upper control panel control module (N72/1) in direction of arrow and disconnect wiring connector (10)	Switch group (11) is a part eliminated and is replaced with new switch group with TS/IRS switch (N72/1s7).
6	Remove headliner	Lay headliner down on seats
			AR68.30-P-4300N
	Install
7	Retrofit transmitter/receiver	Interior motion sensor, transmitter/receiver (A26/14).	AN80.50-P-0100-01M
8	Install headliner
			AR68.30-P-4300N
9	Install upper control panel control module	Use new switch group (11) with TS/IRS switch (N72/1s7).
			AR54.21-P-1262N
10	Fit remaining parts to vehicle
	Inspect
11	Perform control module adaptation of interior motion sensor with STAR DIAGNOSIS.	Perform following control modules adaptation: EIS interior motion sensor
12	Check infrared interior monitoring for proper function
13	Enter special equipment on vehicle data card and in on-line vehicle data card	Infrared interior monitoring (only with ATA) code 882b.