Remove/install accelerator pedal - AR30.12-P-1321I

MODEL 220, 215, 230 

Fig 1: Identifying Accelerator Pedal Remove/Install Components

	Remove/Install
1	Remove key from electronic ignition switch (EIS)	Vehicles with Code (889) Keyless Go: Switch off engine, remove Keyless-Go cards from the vehicle and store outside of transmitter range
2	Remove front cover below instrument panel on left	Model 215	AR68.10-P-1500N
		Model 220	AR68.10-P-1500M
		Model 230	AR68.10-P-1500R
3	Unscrew nut (arrow) attaching accelerator pedal (33)
4	Take out accelerator pedal (33)	Accelerator pedal must not be disassembled otherwise it will be damaged. Installation:  Accelerator pedal must be inserted with front guide lug (arrow) in firewall.
5	Unplug connector of pedal value sensor (B37)
6.1	Unplug connector of kickdown switch (S16/6)	Vehicles with kickdown switch (S16/6)
7	Install in the reverse order