Switching on interior lighting with anti-theft alarm, function - GF82.20-P-2007S
MODEL 220
When the anti-theft alarm (ATA) or a taxi emergency alarm is triggered the front and rear dome lamps are switched on without dimming.
If the alarm is canceled, the lights are switched off again.
Actuation
- In the event of an ATA alarm the left front SAM control module (N10/6) transmits the message "Switch on interior light, ATA" and in the event of a taxi emergency alarm the special vehicle multifunction control module (SVMCM, N26/9) send the message "Switch on interior light, SVMCM" to the CAN bus (passenger compartment).
- The overhead control panel control module (N70) reads this message and actuates the following lights:
- Interior and vanity mirror lamps (E15/10e2) in left rear dome lamp
- Interior and vanity mirror lamps (E15/11e2) in right rear dome lamp
- Front dome lamp (N70e1)
Behavior when voltage is too low or too high
The ATA alarm and taxi emergency alarm function are available even when the voltage is slightly low.
| Switching on/off front dome lamp, function | GF82.20-P-2019S | ||
| Switching on/off rear dome lamp, function | GF82.20-P-2020S | ||
| Anti-theft alarm (ATA), function | GF80.50-P-0001S | ||
| Overhead control panel control module, location/purpose/design/function | GF82.20-P-4101S | ||
| Left signal-acquisition and actuation module (SAM), location/purpose/design/function | GF54.21-P-4101S |