Remove/install Parktronic system (PTS) sensors in front bumper - AR54.65-P-0001I

MODELS 215, 220 with CODE (220a) Parktronic System (PTS) 

Fig 1: Identifying Front Bumper Parktronic System (PTS) Sensor Remove/Install Components - Shows Model 220

Shows model 220 

	Remove/install
1	Unclip bumper element (2) on bumper	Using a suitable tool (e.g. plastic wedge) pry out of bumper and remove in the direction of the arrow.
2	Disconnect coupling (3) from Parktronic sensor (1)	Lift up lock tab (3a) slightly using a suitable tool.
3	Unclip bracket of Parktronic sensor (4) from bumper element	When removing the bracket together with the Parktronic sensor, this can fall out of the bracket.
4	Pull sensor out of the bracket	Installation:  Check sealing ring (5).
5	Install in the reverse order