Remove/install rear rubber bushing in rear axle mount - AR35.10-P-0040-03I

Fig 1: Identifying Extraction Tool (140 589 13 33 00)

Fig 2: Identifying Insertion Tool (220 589 04 43 00)

Remove rubber mount 

Always replace both rear rubber mounts.

1. Place extraction tool (01l, 01m, 01n) on rear axle carrier.
2. Pull rubber mount (1b) out of rear axle carrier.
   Fig 3: Identifying Extraction Tool And Rubber Mount

   

   Install rubber mount 

   Pay attention to installation position. The arrow on the bottom of the rubber mount must point in the direction of travel.

   Two additional arrows on the top left and right of the rubber mount also point in the direction of travel.

   Fig 4: Locating Mount Travel Direction Point

   
3. Grease rubber mount (1b) around circumference with lubricant.
4. Place insertion tool (01o, 01p, 01r) on rear axle carrier.
5. Push rubber mount (1b) into the rear axle carrier.
   Fig 5: Identifying Rubber Mount And Insertion Tool

   

   Insert rubber mount until rubber mount bead is lying against top of rear axle carrier (arrow).

   Fig 6: Locating Rear Axle Carrier