Remove, install front rubber bushing in rear axle mount - AR35.10-P-0040-02MB

MODEL 220 with CODES Z04, Z07

REAR AXLE CARRIER

Number	Designation		MODEL 220 with CODES Z04, Z07
BA35.10-P-1001-01D	Bolt, split rubber mount to rear axle carrier	Nm	20

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1002-06A	Lubricant	A 000 989 01 60

Fig 1: Identifying Extraction Tool (140 589 17 33 00)

Fig 2: Identifying Insertion Tool (140 589 14 33 00)

Remove rubber mounts

Slacken and remove through-bolts for attaching split rubber mounts, if installed.
Position extraction tool (01s) on rubber mount (1f). Tighten both bolts uniformly, so that the claws of the extraction tool to the rubber mount do not slip.
Place extraction tool (01t) on rear axle carrier.
Pull rubber mount (1f) out of rear axle carrier.
Press out upper rubber mount upward using suitable drift.

Fig 3: Identifying Extraction Tool And Rubber Mount

Installing rubber mounts

Install rubber mounts in correct position. Ensure that the side with the more closely adjacent sheet metal plates points in the direction of travel or the bores in the rubber mounts point toward the rear axle carrier.
Grease rubber mount around circumference with liquid lubricant.
Pull upper and lower rubber mount (1f, 1e) into the rear axle carrier using the insertion tool (01u, 01v).
The arrows on the insertion tool (01u, 01v) must point in the direction of travel.
Install bolts for attaching the rubber mounts.

Fig 4: Identifying Rubber Mount And Insertion Tool