Remove/install camber strut - AR35.20-P-0110M

MODEL 215.374 / 376 / 379 

MODEL 220.074 /174 /176 /179 

Fig 1: Identifying Camber Strut Remove/Install Components - Model 215.374

	Remove/Install
	Risk of death  cased by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the parts will be affected
	Notes on self-locking nuts and bolts	All models	AH00.00-N-0001-01A
1	Remove rear axle.	Model 215.374 / 376 / 379, 220.176 / 179	AR35.10-P-0010N
		Model 220.074/ 174	AR35.10-P-0010AM
		Do not remove rear axle from the assembly attachment and secure axle carrier with tensioning strap to prevent it from falling down.
2	Detach camber strut (2) from wheel carrier (3) and rear axle carrier (4)	Installation:  When tightening the camber strut and rear axle carrier the vehicle must be unloaded and on its wheels. Otherwise the rubber mounts are constantly under preload and are damaged as a result.
			*BA35.20-P-1004-02A
			*BA35.20-P-1001-02A
3	Install in the reverse order

CAMBER STRUT

CAMBER STRUT