Remove/install lamp unit - AR82.10-P-4730N
MODEL 215
| Remove/install | |||
| Risk of death caused by touching parts which conduct high voltages | Do not come into contact with parts that are under high voltage. Persons who have electronic implants (e.g. pacemakers) must not perform any work on the ignition system. | AS15.10-Z-0001-01A | |
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/fire due to highly flammable materials in the area of damaged xenon bulbs Risk of injury caused by UV light, hot components on xenon headlamps and glass splinters when xenon bulbs are bursting Risk of poisoning due to inhaling mercury vapors and when swallowing/coming in contact with toxic salts and mercury compounds |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulating safety shoes, safety glasses, and protective gloves. Remove highly inflammable materials from the hazard area. Ensure that the working area is sufficiently ventilated. | AS82.10-Z-0001-01A | |
| 1 | Open engine hood and move to vertical position | AR88.40-P-1000M | |
| 2 | Remove front bumper | AR88.20-P-2000M | |
| 3 | Remove bolts (1, 2) | ||
| 4 | Remove left lamp unit (E1) in direction of vehicle center | ||
| 5 | Unclip electrical connections (3a, 3b) and remove | Connection (3c) to front fog lamp does not have to be removed | |
| 6 | Install in the reverse order | ||
| Checking | |||
| 7 | Check and correct headlamp adjustment | AP82.10-P-8260M |