Remove/install paneling on C-pillar - AR68.30-P-4490M

MODEL 220 

Fig 1: Identifying Removal/Installation Paneling On C-Pillar - Model 215

	Remove, Install
1	Detach edge guard in area of paneling parts (1 and 6)
2	Remove lumbar support control valve		AR91.12-P-1670M
3	Remove inner door sill molding	Door sill molding is screwed in area of lumbar support control valve (arrow)
4	Remove wheel well paneling (6)
5	Pry paneling (1) out of C-pillar with clip nuts (2)	Press clip nuts out together with C-pillar paneling.
			Figure
	Guide hook (3) out at headliner (5)
6	Pull paneling (1) with catch lugs (4) out of rear shelf toward front
7	Unscrew screw (7) from belt end fitting (8) of rear seatbelt and pull belt out of paneling (1)		*BA91.40-P-1001-01A
8	Install in the reverse order

SEAT BELTS/BELT TENSIONERS

Number	Designation		Model 220
BA91.40-P-1001-01A	Screw on belt end fitting	NM	30

Special tool 

Fig 2: Identifying Assembly Wedge (115 589 03 59 00)