Removing and installing side member trim - AR88.80-P-6000N

MODEL 215 

Fig 1: Identifying Side Member Trim Remove/Install Components (1 Of 2)

Fig 2: Identifying Side Member Trim Remove/Install Components (2 Of 2)

	Removal, installation
1	Remove covers (8) and (9)
2	Remove edge guard (10) in entry area
3	Lift entry cover (11) with assembly wedge	Installation:  Replace damaged mounting clips	Figure
4	Remove spreading rivets (4)
5	Unscrew screws (6) and (7)
6	Unscrew screws (3) and press rocker panel (1) off with assembly wedge downward at front and rear (arrows)		Figure
7	Remove seal (2) and unclip rocker panel (2) from longitudinal member	Installation  : Hook rocker panel (1) into clamps (5)
8	Install in opposite order

Fig 3: Identifying Assembly Wedge (110 589 03 59 00)