| 1 |
Remove front seats |
|
AR91.10-P-1000GH |
| 2.1 |
Remove bass module speaker |
Only with Sound-System, Code 810. |
AR82.62-P-7839GH |
| 3.1 |
Remove control module for emergency call system |
Only with emergency call system E-Call, Code 349. |
AR82.95-P-0008GH |
| 4 |
Remove bench |
1/3 bench seat, up to 31.8.99. |
AR91.12-P-1010GH |
| |
|
40% bench seat, as of 01.9.99. |
AR91.12-P-1010GI |
| |
|
2/3 bench seat, up to 31.8.99. |
AR91.12-P-1010GJ |
| |
|
60% bench seat, as of 01.9.99. |
AR91.12-P-1010GK |
| 5 |
Remove rear seat anchors (2) |
Up to 31.8.99, unscrew internal Torx drive bolts (3). |
|
| |
|
Torx bit set |
Figure |
| 6 |
Remove center console (4) |
|
AR68.20-P-2000GH |
| 7 |
Remove cover below instrument panel on left (6) |
|
AR68.10-P-1500GH |
| 8 |
Remove cover below instrument panel on right (5) |
Up to 31.8.99. |
AR68.10-P-1520GH |
| |
|
As of 01.9.99. |
AR68.10-P-1520GI |
| 9 |
Unscrew plastic nuts (11) in right footwell |
|
|
| 10 |
Remove condensate water drain hose from heater housing |
|
|
| 11 |
Remove door sill molding on right (9) and door sill molding on left (10) |
|
AR68.30-P-4100GH |
| 12 |
Remove paneling in footwell on right (7) and paneling in footwell on left (8) |
|
AR68.30-P-4010GH |
| 13 |
Remove insulating mat under the center console |
|
|
| 14 |
Remove air duct for ventilation in the rear |
|
|
| 15 |
Remove radio |
|
AR82.60-P-7502EA |
| 16 |
Disconnect all the electrical connectors and lay aside |
|
|
| 17 |
Detach shift-lock cable at the electronic selector module |
|
|
| 18 |
Remove bracket between instrument panel center part and transmission tunnel |
 |
*BA68.10-P-1003-01A |
| 19 |
Pull out floor covering (1) in area of C-pillar and remove |
Do not damage electrical leads.
Installation:
Align floor covering at attachment points for seats and thread electric wires through corresponding cutouts. |
|
| 20 |
Install in the reverse order |
|
|