Fault code description - ME-SFI - modulating pressure control solenoid - AD07.61-P-4000-36A

1	Fault code	P0748
2	Fault storage	after the end of the test period and faults
	Activation of malfunction indicator lamp for engine diagnosis (EURO3/4) or CHECK ENGINE (MIL)	after two successive driving cycles with faults
3	Frequency of the test	continuous
4	Checked signal or status	Activation of modulating pressure control solenoid
5	Fault setting conditions	< 0.4 V
	Short circuit to ground	approx. 8.5 V
	Lower limit, voltage	approx. 15 V
	Upper limit, voltage	approx. 0.300 A
	Lower limit, current	approx. 0.700 A
	Upper limit, current	approx. 1 s
	Test duration
6		Faults (activation of line interruption or short circuit, short circuit in the valve) are detected by the ETC control module and sent via the CAN data bus to the ME-SFI control module. The faults are stored and the "CHECK ENGINE" malfunction indicator lamp (MIL) is activated by the ME-SFI control module. Also read out ETC diagnostic trouble code memory, fault code 6.