Fault code description - ME-SFI - intake air temperature sensor - AD07.61-P-4000-03A

1	Fault code	P0110
2	Fault storage	after the end of the test period and faults
	Activation of malfunction indicator lamp for engine diagnosis (EURO3/4) or CHECK ENGINE (MIL)	after two successive driving cycles with faults
3	Frequency of the test	continuous
4	Checked signal or status	Limits for intake air temperature
5	Fault setting conditions	Fault, if signal is less than 0.1 V (corresponds to approx. 300 kΩ and approx. -50 °C)
	Lower limit	Fault, if signal is greater than 4.93 V (corresponds to approx. 92 Ω and approx. +150 °C)
	Upper limit	approx. 1 s
	Test duration
6		In the event of a fault, driving continues at the substitute value +20 °C. If the signal becomes plausible again, the system changes over to the signal from the intake air temperature sensor.