Fault code description - ME-SFI - gear comparison (multiple times) negative - AD07.61-P-4000-33A

1	Fault code	P0730
2	Fault storage	after the end of the test period and faults
	Activation of malfunction indicator lamp for engine diagnosis (EURO3/4) or CHECK ENGINE (MIL)	after two successive driving cycles with faults
3	Frequency of the test	continuous
4	Fault setting conditions	Comparison of detected gear and engaged gear (calculated gear ratio) negative at least 6x
5	Test prerequisites	2nd, 3rd, 4th or 5th gear detected engine speed > 450 rpm output shaft rotational speed > 180 rpm no shift operation
6		The gear ratios are calculated from the following variables: speed signal n2, speed signal n3 and output shaft rotational speed (determined via rear wheel speed). Faults are detected by the ETC control module and sent via the CAN data bus to the ME-SFI control module. The faults are stored and the malfunction indicator lamp is activated by the ME-SFI control module. Also read out ETC diagnostic trouble code memory, fault code 55.