Fault code description - ME-SFI - ETC control module - AD07.61-P-4000-29A
| 1 | Fault code | P0702 |
| 2 | Fault storage | after the end of the test period and faults |
| Activation of malfunction indicator lamp for engine diagnosis (EURO3/4) or CHECK ENGINE (MIL) |
after two successive driving cycles with faults | |
| 3 | Frequency of the test | continuous |
| 4 | Checked signal or status | Fault in ETC control module CAN communication
|
| 5 | Faults are detected by the ETC control module and sent via the CAN data bus to the ME-SFI control module. The faults are stored and the malfunction indicator lamp is activated by the ME-SFI control module. Also read out ETC diagnostic trouble code memory, fault code 56-65. |