Remove/install door catch - AR72.10-P-2100GH

MODEL 163.113 /128 /136 /154 /157 /172 /174 /175

Fig 1: Identifying Door Catch Components

G04608339

	Removing, installing
1	Remove door lining	Front door	AR72.10-P-1000GH
		Rear door	AR72.12-P-1010GH
2	Pull foil off of inner door panel in front area	Installation: Replace damaged foil.
3	Unscrew screw (1) on door retraining strap	Avoid damaging paint. Installation: Apply glue to screw.	*BR00.45-Z-1011-02A
			*BA72.10-P-1001-01D
			*BA72.12-P-1003-01C
4.1	Pull seal (3) off of door retaining strap (5)	Up to 08/99.
5	Close crank window
6	Unscrew nuts (6) from door retaining strap	Hold door retaining strap to prevent it from falling into the door
			*BA72.10-P-1002-01D
7	Remove door retaining strap through installation opening in inner door panel	Pull rubber out of retaining clip at bottom of window guide rail and move along door catch. Installation: Install window guide rail correctly.
8	Install in the reverse order

TORQUE SPECIFICATION

Front door

Number	Designation		MODEL Series 163
BA72.10-P-1001-01D	Bolt, door catch at A-pillar	Nm	24
BA72.10-P-1002-01D	Nut for door restraining strap on inside of door	Nm	10

TORQUE SPECIFICATION

Rear door

Number	Designation		MODEL Series 163
BA72.12-P-1003-01C	Screw for door catch on B-pillar	Nm	24

Repair materials

Number	Designation	Order number
BR00.45-Z-1011-02A	Quick glue	A 003 989 31 71