LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2001 >> ML430 >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Electrical System - Body -- 163 Chassis >> Retrofitting & Conversion >> Retrofitting Traffic Pro wiring harness - AZ82.61-P-0002-01H

Retrofitting Traffic Pro wiring harness - AZ82.61-P-0002-01H

Model 163 with transmission 722 up to 30.6.2000 

  1. Prepare adapter wiring harness (4) as shown in figure.
  2. Cut off orange (or) lead for reverse lamp signal (2) at connector (C) and provide with contact spring.

    IMPORTANT Connector (C) no longer required after cutting off.

    Fig 1: Identifying Traffic Pro Wiring Harness
    G04608794
  3. Insert contact spring of orange lead for reverse lamp signal (2) into radio connector (A) chamber 2 of adapter wiring harness (4).
    Fig 2: Identifying Radio Connector And Adapter Wiring Harness
    G04608795
  4. Route adapter wiring harness (4) in vehicle along existing wires as shown in figure.
    Fig 3: Identifying Telephone/GPS Antenna Splitter And CAN Bus Adapter
    G04608796
  5. Connect adapter wiring harness (4) to radio counter connector (7) on standard wiring harness and Traffic Pro navigation system (1).
    Fig 4: Identifying Adapter Wiring Harness And Radio Counter Connector
    G04608797
  6. Connect antenna extension lead (41) to Traffic Pro navigation system as shown in figure.
    Fig 5: Identifying Antenna Extension Lead
    G04608798
  7. Route tieout to CAN bus adapter (5) from adapter wiring harness (4) as shown in figure toward rear on middle tunnel.
    Fig 6: Identifying CAN Bus Adapter And Adapter Wiring Harness
    G04608799
  8. Position CAN bus adapter mount on center console brace as shown in figure and mark holes (arrows).
  9. Drill 6.2 mm dia. mounting holes
    Fig 7: Identifying Mark Holes
    G04608800
  10. Fasten CAN bus adapter (5) with self-tapping screws from CAN bus adapter parts kit.
    Fig 8: Identifying CAN Bus Adapter
    G04608801
  11. Install white (ws) and blue (bl) fuse on connector for transfer case control module (N78) from CAN bus wiring harness (9) as shown in figure.
    Fig 9: Identifying Transfer Case Control Module And CAN Bus Wiring Harness
    G04608802
  12. Disconnect connector from transfer case control module (N78) and connect CAN bus wiring harness (9) between transfer case control module (N78) and standard wiring harness.

    IMPORTANT Illustrated without center console

  13. Connect CAN connector (6) from CAN bus wiring harness (9) to CAN bus adapter (5).
    Fig 10: Identifying CAN Bus Adapter And CAN Connector
    G04608803
scientia non olet · About LEMON Manuals