Retrofitting telephone console - AZ82.70-P-0001-01C

Model 163 as of 1.12.99 up to 31.8.00 for Nokia 6090 fixed installation CTEL 

1. Remove cover (1 a) from telephone handset mount (1).
2. Insert assembly plate (10) below into mount (1).
   Fig 1: Identifying Cover For Telephone Handset Mount

   
3. Place mount (1) onto telephone console (12) as shown in figure and align. Mark hole pattern and drill with 2.5 dia. bit.
4. Attach mount (1) to telephone console (12) with screws (11).
5. Insert cover (1a) again.
   Fig 2: Identifying Mount, Telephone Console And Screws

   
6. Install telephone handset (8), insert spiral cable as shown in figure with the fifth spiral into the opening of the telephone console and fix in place with adhesive felt (arrow).
   Fig 3: Identifying Telephone Console And Telephone Set Mount

   
7. Insert plug connection of telephone wiring harness (2) into bottom part of housing as shown in figure and fit on top part of housing.
   Fig 4: Identifying Telephone Wiring Harness

   
8. Fit connection cable of telephone wiring harness (2) to spiral cable (comes from radio slot). Pull foam rubber grommet over connector.
9. Push telephone console (12) below the wood trim cover (arrows) and press against right tunnel wall.
10. Mark hole for screw (13) and drill with Ø 5 mm.

    When drilling, pull tunnel wall out slightly so that parts behind cannot be damaged. 

11. Install clip nut (14) on tunnel wall and install screw (13).
12. Push connection cable (2) below tunnel wall.
    Fig 5: Pushing Telephone Console