LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2001 >> ML430 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Accessories Control Systems >> Electrical System, Equipment & Instructions -- 163 Chassis >> Retrofitting & Conversion >> Installing instrument - AZ54.65-P-0001-05J

Installing instrument - AZ54.65-P-0001-05J

Model 163.1 without code 849 

  1. Mark the center point of the mounting hole for the display instrument on the removed right, side trim of the roof frame as per the diagram.

    IMPORTANT The center line of the seat belt slot serves as a reference line for the dimensioning.

  2. Make a 30 mm dia. mounting hole at the marked drilling point and clip the display instrument (1) into the trim.
  3. When attaching the trim, route the display instrument connection cable downwards and behind the right rear trim, route forwards to the control module installation point.

    IMPORTANT Tie connection cable to existing cables or wiring looms. Pay attention to chafe-free routing and attach chafe protection if necessary.

    Fig 1: Identifying Positions 30 Mm Dia. Mounting Hole And Display Instrument
    G04607867
scientia non olet · About LEMON Manuals