Checking and adjusting control point of level control - AR40.20-P-0310C
MODEL 210
| Checking | |||
| 1 | Check and adjust vehicle level at front and rear axles | ||
| Models 210.00/01/02/03/04/05/06/07/20/21/ 22/23/24/26/27 | AR40.20-P-0300C | ||
| 1.1 | Check vehicle level at front and rear axle with electronic inclination measuring instrument and adjust, if necessary | ||
| Models 210.00/01/02/03/04/05/06/07/20/21/22/23/24/26/27 | AR40.20-P-0301C | ||
| Models 210.08/28/6 | AR40.20-P-0301D | ||
| 2 | Check oil level in level control | Correct if necessary. | AP32.30-P-3211BB |
| 3 | Pull down rear of vehicle to the specified control point (simulate loading condition). Hook pulling device (040b) with mounting pin (040g) onto frame floor next to the rear mount of the rear axle carrier and lock (arrows). Place measuring device (02) on inside of spring link | *BE40.20-P-1001-04A | |
| *BE40.20-P-1002-04A | |||
| 201589113100 | |||
| Figure | |||
| Adjusting | |||
| 4 | Push in, pull out 4 mm alignment tool through the bore (arrow) in adjusting lever (3a) of level control (3) | When the adjustment is correct, the alignment tool can be pushed into the positioning bore in the level controller. If the adjustment is defective , loosen adjuster of connecting rod (55a). Fix adjusting lever (3a) of level controller (3) in position with 4 mm alignment tool through the bore (arrow) and tighten connecting rod adjuster in this position. |
Control point of level control - rear axle
| Number | Designation | Model 210.0 except 210.08 | Model 210 Avantgarde/ sports suspension | Model 210.2 except 210.28 | Models 210.08/28 | Model 210.6 | |
|---|---|---|---|---|---|---|---|
| BE40.20-P-1001-04A | Control point of rear axle | mm | - 8 ± 10 | -25 ± 10 | 0 ± 10 | 0 ± 10 | +15 ± 10 |
| BE40.20-P-1002-04A | Control point of rear axle | ° | - 1,1 ± 1,0 | -2,8 ± 1,0 | - 0,3 ± 1,0 | -0,3 ± 1,0 | +1,3 ± 1,0 c |