Removing and installing front spring - AR32.20-P-0200FB

MODEL 210.07 with CODE (979) Special protection version with CODE (Z04) Light armoring with CODE (Z06) B6 armoring 

Fig 1: Identifying Front Spring Components (Model 210.07)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removal, installation
	General on springs	Models 129, 140, 168, 170, 202, 210	AH32.20-P-9404-01A
1	Install tensioning plates (01b, 01c).		Figure
2	Install spring compressor (01a).		Figure
		Alternatively	Figure
	Injury hazard!  Springs or spring elements under pressure can pinch and crush body parts during work.	Use only approved spring compressors and also shield hazard area if applicable. Check special tools for damage and proper function (visual check). Wear protective gloves	AS00.00-Z-0001-01A
3	Compress front spring		AR32.20-P-0200-01A
4	Remove front spring (12) toward front together with rubber mount (13).	Clean wishbone (31) in area of contact surface. After replacing the front spring or rubber mount ↓
		Check headlamp adjustment, correct.	AP82.10-P-8260A
5	Reinstall in opposite order

Fig 2: Identifying Spring Compressor (202 589 01 31 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Spring Compressor (202 589 02 31 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 4: Identifying Tensioning Plates (202 589 13 63 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.