Retrofitting seat belts for folding seat - AN91.40-P-0690-01FA

Seatbelts/emergency tensioning retractors

Number	Designation		Model 210
BA91.40-P-1001-01A	Screw on seat-belt end fitting.	Nm	35
BA91.40-P-1005-01A	Screw in rear upper belt guide fitting	Nm	30
BA91.40-P-1006-01A	Screw at rear belt retractor	Nm	30
BA91.40-P-1007-01A	Screw on rear buckle	Nm	30

1. Insert belt retractor into fixture and fasten in place using hexagon screw and washer.

   Make sure that the belt retractor is locked in place.

2. Snap covering for belt outlet on inner panel into place.
   Fig 1: Identifying Fixture For Belt Retractor, Hexagon Screw With Washer And Cover

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
3. Screw on seat-belt turning loop and push cap on.
   Fig 2: Identifying Seat-Belt Turning Loop, Cap And Vehicle Without Windowbag

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
4. Screw on belt end fitting and mount belt end-fitting cover with lashing points.
   Fig 3: Identifying Belt End Fitting, Covering And Lashing Points

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
5. Remove sealing screw and feed belt buckle through the floor lining in the center.
6. Align belt buckle with catch and screw tight.
   Fig 4: Identifying Center Floor Lining, Belt Buckle And Catch

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.