Retrofitting inclination sensor - AN80.50-P-0001-05A

Model 210 as of 01.03.97 

1. Position inclination sensor (B3) to present hole with threaded pin of bracket on right in rear seat firewall and align inclination sensor so that arresting lug (arrow) catches in arresting hole.
2. Tighten inclination sensor with washer (2) and nut (3).
3. Connect 6-pin connector (1) for ATA/TS wiring harness to inclination sensor.
   Fig 1: Connecting 6-Pin Connector For ATA/TS Wiring Harness To Inclination Sensor

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.