Retrofitting wiring harness of CD changer - AZ82.64-P-0001-01C

Model 210.2 as of 1.7.98 except code 316, 317, 347 

1. Prepare CD changer (1) wiring harness as shown in figure.
2. Insert black lead (sw) from power supply wiring harness for CD changer (3) into chamber 5 and brown lead (br) into chamber 6 of black 10-pin connector on D2B wiring harness (2).
3. Solder remaining blue/black leads from both wiring harnesses together as shown in figure using solder connector (a) as end sleeve for D2B wake-up signal (fiber optic network) (Z35/10).
   Fig 1: CD Changer Wiring Harness Diagram

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
4. Route wiring harness (1) along existing leads in vehicle as shown in figure.
   Fig 2: Identifying CD Changer Wiring Harness

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
5. Route CD changer (1) wiring harness along existing leads in load compartment as shown in figure.
   Fig 3: Identifying CD Player With Changer

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
6. Route tie-out to radio (A2) in wiring duct below driver's seat as shown in figure and fasten with felt.
   Fig 4: Identifying CD Changer Wiring Harness And Blue/Black Wake-Up Signal Leads

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
7. Route tie-out to radio in radio shaft.
   Fig 5: Identifying CD Changer Wiring Harness And Black 10-Pin Connector For CD Changer

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
8. Route end sleeves for wake-up signal (Z35/10) from CD changer wiring harness (1) in wiring duct on left B-pillar.
   Fig 6: Identifying End Sleeves For Wake-Up Signal

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.