Retrofitting wiring harness of CD changer - AZ82.64-P-0001-01A

Model 210.0 as of 1.7.98 except code 316, 317, 347 

1. Prepare CD changer (1) wiring harness as shown in figure.
2. Insert black lead (sw) from power supply wiring harness for CD changer (3) into chamber 5 and brown lead (br) into chamber 6 of black 10-pin connector on D2B wiring harness (2).
3. Solder remaining blue/black leads from both wiring harnesses together as shown in figure using solder connector (a) as end sleeve for D2B wake-up signal (fiber optic network).
   Fig 1: CD Changer Wiring Harness Diagram

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
4. Route wiring harness (1) along existing leads in vehicle as shown in figure.
   Fig 2: Identifying CD Changer Wiring Harness

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
5. Route CD changer wiring harness (1) along existing leads from trunk to left Bpillar as shown in figure.
   Fig 3: Identifying CD Changer Wiring Harness Components

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
6. Insert end sleeves for wake-up signal (Z35/10) into wiring duct on left B-pillar.
   Fig 4: Identifying CD Changer Wiring Harness And Blue/Black Wake-Up Signal Lead

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
7. Route tie-out to radio (A2) in wiring duct below driver's seat as shown in figure and fasten with felt.
   Fig 5: Identifying Radio Wiring

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
8. Route tie-out to radio in radio shaft.
   Fig 6: Identifying CD Changer Wiring Harness, CD Changer Connector And D2B Connector

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.