Retrofit portable CTEL mounting of hands-free system - AZ82.70-P-0005-01F

Align base holder (2) on console (12), mark holes and drill with 3mm dia. bit.
Screw base holder onto console (12) with the 3 sheet metal screws (3) included

Fig 1: Identifying Sheet Metal Screws
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Insert portable cellular telephone holder (1) into base holder (2).
Hook connection lead below console (12) with coil of spiral lever as shown in figure (arrow) and arrest from inside with adhesive felt.

Fig 2: Identifying Portable Cellular Telephone Holder Into Base Holder
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Route connector (8) and antenna for telephone handset (A34) into radio shaft.

Fig 3: Identifying Connector And Antenna For Telephone Handset Into Radio Shaft
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.