Installing instrument - AZ54.65-P-0001-05B

Models 210.0/6 with code 290 or 293 up to 30.06.99 

Models 210.0/6 as of 01.07.99 

1. Mark the center point of the mounting hole for the display instrument on the removed right C-pillar trim as per the diagram.

   The center line of the seat belt slot serves as a reference line for the dimensioning.

2. Make a 30 mm dia. mounting hole at the marked drilling point and clip the display instrument (1) into the trim.
3. Route the display instrument connection cable downwards when attaching the trim.
4. Route the connection cable backwards from the C-pillar and in the trunk, route to the left to the control module installation point.

   Tie connection cable to existing cables or wiring looms. Pay attention to chafe-free routing and attach chafe protection if necessary. Tie back cable if overlength.

   a = 30 mm 

   b = 35 mm 

   Fig 1: Drilling Point And Clip Display Instrument Into Trim

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.