Manual raising/lowering of power windows function - GF72.29-P-3006KA

MODELS 208.435 /444 /445 /447 /448 /465 /470 

Function prerequisites 

• No overvoltage/undervoltage
• Circuit 15 on or circuit 15R on

Manual window raising/lowering function 

The manual window raising/lowering function is triggered by pressing the power window switch as far as the first click-stop position in the "open" or "close" direction. Each power window can be operated individually.

• Front power windows 

  On pressing the left front power window switch, front center console (S21/1)  or the right front power window switch, front center console (S21/2)  the corresponding door control module receives a CAN message from the roll bar (RB)/soft-top operation control module (N52)  and actuates the relevant power window motor  until another switch position is signaled.

• Rear power windows 

  On pressing the left rear power window switch (N72s3)  or theright rear power window switch (N72s4)  the roll bar (RB)/soft-top operation control module (N52)  receives a CAN message from the lower control panel control module (N72)  and actuates the relevant power window motor  until another switch position is signaled.

Interruption of the manual window raising/lowering function 

The function is aborted if

• lock-up  of the power window is detected,
• switch S21/1 or S21/2 is pressed continuously for more than 25 s
• the function prerequisites are no longer satisfied.

	Position recognition for power windows		GF72.29-P-4000KA
	Power windows in front doors		GF72.29-P-4101A
	Open/close rear window, function		GF67.39-P-3001KA
	Driver-side front door control module		GF72.29-P-4105A
	Passenger-side front door control module		GF72.29-P-4106A
	Power window switch, center console		GF72.29-P-4103KA
	Roll bar/soft-top operation control module, location/task/design/function		GF77.39-P-3100KA