Replacing seal on glass sliding/pop-up roof - AR77.20-P-1350K

MODEL 208.3 

Fig 1: Replacing Seal On Glass Sliding/Pop-Up Roof

	Removal
1	Remove sliding/pop-up roof cover		AR77.20-P-1000K
2	Pull seal (1) off of glass cover	Mark joint in seal (1) on glass cover
	Installation
3	Apply lubricant all around base of seal (1), position on mark and press into insert profile (4) on glass cover up to joint with roller (2)		*BR00.45-Z-1010-06A
			Fig 2
5	Cut off seal (1) at joint leaving 1 mm excess and press into insert profile (4)	Ensure that transition is precise
6	Measure seal (1) in relation to glass cover	Seal (1) to outside of glass cover: 7 mm
		The adjustment dimension for the seal (1) can be changed by pressing from outside or top with roller (2). Use a suitably rounded plastic wedge (5) to increase in area of side covers and radius
7	Install glass cover		AR77.20-P-1000K

Fig 2: Identifying Roller (168 589 05 63 00)

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1010-06A	Antifriction agent	A 000 989 03 67